This is already my third post about Me & My Fablab. Today the challenge was to print a bracelet.
It is amazing how the 3D community is working, you can learn all about 3D design and printing on the internet for free on sites like TinkerCad and Thingiverse. For more links you can visit FabLab.
You can use one of the interesting 3D designs and print it in your own FabLab, add some changes and improve the design.
So I found the following bracelet on Thingiverse, translated it to TinkerCad and printed it!
See my steps and the results in photos.
Do you like to learn this too? Come join me at FabLab Zoetermeer.
See also my previous posts on Me & My FabLab:
Me & My FabLab - 3D printing keyring including a short film!
Me & My FabLab the introduction!
It is amazing how the 3D community is working, you can learn all about 3D design and printing on the internet for free on sites like TinkerCad and Thingiverse. For more links you can visit FabLab.
You can use one of the interesting 3D designs and print it in your own FabLab, add some changes and improve the design.
So I found the following bracelet on Thingiverse, translated it to TinkerCad and printed it!
See my steps and the results in photos.
Do you like to learn this too? Come join me at FabLab Zoetermeer.
See also my previous posts on Me & My FabLab:
Me & My FabLab - 3D printing keyring including a short film!
Me & My FabLab the introduction!
Me & My FabLab: 3D printing bracelet
Reviewed by Patricia Munster
on
11:40:00 AM
Rating:
Reviewed by Patricia Munster
on
11:40:00 AM
Rating:
.jpg)
Posts
No comments: